Control by 3-servo-motors and computer. Hard disk used for improved data management and setting changes.

>> General Structural Diagram (PDF documents)

* This file is stored in PDF format which requires Adobe Acrobat Reader for viewing.
If you do not have Acrobat Reader installed on your computer, click this banner to install.

	Characteristic

The HSP-350-SP employs two Servo motors for film feeding and one independently operating AC Servo motor for the regulation of the raising and lowering movement of the sealing units. It is possible to set the sealing time voluntarily. It is also possible to change the running speed while maintaining a standard sealing time and temperature.
The percentage of time and product loss occurring when setting the initial operating conditions has become extremely slight due to loading by personal computer, which has made possible the printing out and filing of the data of production conditions. Standard pouches, air-tight pouches and pouches containing paste-like contents can be produced at a stable sealing strength and at high speed accuracy.

	Specifications

Web Width	120mm-800mm
Web Diameter	Max. 600mm
Pouch Size Range	W=50mm-350mm L=50mm-400mm
Gusset depth	MAX 80mm at maximum web width of 800mm
Machine weight	6500kg (Approx.)
Main Web Stand	Single Web Stand
Main Web Shaft	Cone tightening type
Main Web Brake	NIRECO Tension Controller
.	Gusset Unit
.	NIRECO Edge Position Controller (Ultrasonic sensor)
Plate Length	2000mm
Center Sealing Unit	520mm, 420mm
Longitudinal Cooling Unit	W30mm * L420mm
Gusset Unit (Plate Length)	450mm/430mm
Side Sealing Length	520mm
Side Cooling Length	420mm
Bottom Sealing Unit	3 units(fine-adjustment: 2 units)
Bottom Cooling Unit	1 unit
Monitor	Touch Screen
Table Conveyor	Up and down movement (Fixed with frame)
Thermostat	12 pcs., Upper and lower limit warning
Alarms	Start Discharge, Web Run Out, Web End, Web Splice
Accessories	Guillotine knives : 1set, Seal Bar (Longitudinal / Bottom) : 20pcs., Tools : 1set
Thermocouple	Attaching type
Option	Second Stage Unwinder Powder Sprayer Accumulator Tape inserter (with semi-automatic splicer) Skip Drive Punching Unit Evacuation Unit Diagonal cutting unit
Power	AC200V 3P Motor load 13.8kW AC200V single phase heater load 18kW (Excluding compressor)
Cooling water	10-15 liters/min.
* Operating system is Windows XP. * The above values and the configuration may be changed for improvement without previous notice. * Machine specifications are slightly defferent from Japanese ones. Please ask our sales staffs for details.

Page Top