Control by 3-servo-motors and computer. Hard disk used for improved data management and setting changes.

>> General Structural Diagram (PDF documents)

* This file is stored in PDF format which requires Adobe Acrobat Reader for viewing.
If you do not have Acrobat Reader installed on your computer, click this banner to install.

	Characteristics

The HSE-600-SP employs two servo motors for film feeding and one independently operating AC servo motor for the regulation of the raising and lowering movement of the sealing units. It is possible to set the sealing time voluntarily. It is also possible to change the running speed while maintaining a standard sealing time and temperature.
The percentage of time and product loss occurring when setting the initial operating conditions has become extremely slight due to loading by personal computer, which has made possible the printing out and filing of the data of production conditions. Irregardless of who operates the machine the production conditions for the same product can easily be set up each time production begins.

	Specifications

Production Speed	30-200 cycles/min. * The production speed may be affected by the type of material and the cutting length.
Web Width	400mm-1250mm   Web Diameter/800mm
Production Lane	1-3 lanes
Pouch Size Range	W = 75mm - 600mm, L= 50mm - 500mm
Machine Weight	6500kg (Approx.)
Main Web Stand	Horizontal Single Web Stand
Main Web Shaft	3-inch Air Shaft
Main Web Brake	Automatic Control by value input
L.P.C.	Mitsuhashi Line Position Controller
Longitudinal Sealing Unit	Heater (L:620mm) : 4pcs.(W:80/50/50/80mm), Rubber Base
Longitudinal Cooling Unit	Cooling Bar (L:520mm) : 4pcs.(W:70/30/30/70mm), Rubber Base
.	Razor Unit at the middle feed roller
Bottom Sealing Unit	3units
Bottom Cooling Unit	2units
Razor Unit at the front feed roller	Razor Holder : 4pcs., Trimming Guide
Monitor	Touch Screen
Table Conveyor	Up and down movement (Separate type)
Thermostat	12 pcs., Upper and lower limit warning
Alarms	Start Discharge, Web Run Out, Web End, Web Splice
Accessories	Guillotine knives : 1set, Seal Bar (Longitudinal / Bottom) : 20pcs., Tools : 1set
Thermocouple	Attaching type
Option	Second Stage Unwinder 2-roll Feeding System Floor Pick Up NIRECO Tension Controller Accumulator Skip Drive Powder Sprayer Punching Unit In-line Corner Punching Unit Evacuation Unit Twin Cutter Cutter Controller
Power	AC200V 3P Motor load 13.8kW, AC200V single phase heater load 28kW
Cooling water	10-15liters/min.
* Operating system is Windows XP. * The above values and the configuration may be changed for improvement without previous notice. * Machine specifications are slightly defferent from Japanese ones. Please ask our sales staffs for details.

Page Top