Reliable, cost-effective, and user-friendly.

>> General Structural Diagram (PDF documents)

* This file is stored in PDF format which requires Adobe Acrobat Reader for viewing.
If you do not have Acrobat Reader installed on your computer, click this banner to install.

	Characteristics

This machine handles low materials for pouches used for light products. Two servo motors used, one for film feeding, and one for controling movement of the bottom sealing units. Both seal time and speed can be adjusted or maintained as one or the other are varied.
Each set-up can be stored in the computer for future reference or printed as desired.

• Adjustment for setting and bottom sealing time.
• E.P.C.(Edge Position Controller) with ultrasonic sensor and no adjustment is required.
• Remote controlles E.P.C. head.
  (on the table and the forming area)
• User-friendly touch screen.
• Automatic setting for photo eye sensor.
• Sealing units lift away during stoppage.
• djustable table conveyor.
• Alarm and automatic stop function at end of roll. Meter to measure length.

	Specifications

Production speed	60-250 cycles/min. Film running speed: 50m/min. * The production speed may be affected by the type of material and the cutting length.
Film size range	Width: 120mm-800mm, Diameter: 600mm
Pouch size range	Width: 50mm-350mm, Length: 50mm-400mm
Gusset depth	Max. 80mm
Machine weight	4,500kg(Approx.)
Main Web Stand	Single Web Stand
Main Web Shaft	Cone tightening type
Main Web Brake	NIRECO Tension Controller
	Gusset Unit
Plate Length	1000mm
Center Sealing Unit	320mm
	Knurling device
	Air cooling type
Rubber roller	Film drawing rubber roller (Double roll type)
Side Sealing Unit	420mm (Center Cooling method)
Bottom Sealing Unit	2 units
Bottom Cooling Unit	1 unit
Table Conveyor	Up and down movement (Fixed with frame)
Thermostat	8 pcs., Upper and lower limit warning
Alarms	Start Discharge, Web Run Out, Web End, Web Splice
Accessories	Guillotine knives : 1set, Seal Bar (Longitudinal / Bottom) : 20pcs., Tools : 1set
Thermocouple	Attaching type
Option	Second Stage Unwinder Powder Sprayer Skip Drive Punching Unit Evacuation Unit
Power	AC200V, 3 phase motor load 6kW, AC heater load 14kW,
Cooling water	3-5 Liters/min.
* The above values and the configuration may be changed for improvement without previous notice. * Machine specifications are slightly defferent from Japanese ones. Please ask our sales staffs for details.

Page Top